Bob Paton - Memphis Web SEO :: Arts-and-Entertainment :: Programming the Satellite TV Receiver

href="http://www.dish-network-satellite-tv.ws/">Dish Network
Satellite TV. How To Program Your Satellite TV
Receiver

Setting up your satellite system isn"t as difficult as you might
think. In addition to installing the dish itself, you"ll need to
program that little black box known as your satellite receiver.
Don"t know where to start? Not to worry"� just follow these steps
and you"ll be up and running in no time at all.

Assuming your dish is already installed and your receiver is
properly connected, turn your receiver and your television set
ON. You"ll see a screen called "�Point Dish/Signal Strength
Setup"� where you"re going to test the reception from your
satellites.

Choose the "�Check Switch"� option and you"ll see a new screen.
Choose "�Check"� or "�Test"� and you"ll get a message that your
system check is in progress. When the test is complete, you"ll
see an Installation Summary on your screen that shows reception
details for two satellites. href="http://www.dish-network-satellite-tv.ws/">DISH Network
customers will see data for two satellites: 110 West and 119
West. Transponders should show "�ALL"� and the message "�Satellite
Reception Verified"� in the status area. You can exit this screen.

Now look at your Point Dish/Signal screen again. Do you show
good strength under the 119 West listing? If so, move the check
mark to the 110 West listing. Do you show good strength there as
well? If not, you"ll need to go back and fine-tune your dish
positioning until you have the strongest possible signal from
both satellites. Once you"re satisfied with your signal
strength, you"re ready to download your software. Simply exit
the Point Dish/Signal Strength menu and you"ll be prompted to
confirm that your dish positioning is complete. Answer "�Yes"� and
another prompt will appear confirming the download of your
programming software. Let the software download completely - do
not interrupt this process.

Once the receiver"s memory has been upgraded, you"ll need to
order your programming. href="http://www.dish-network-satellite-tv.ws/">DISH Network
customers can press the "�SYS INFO"� button on the receiver front
panel. This will display the "�Important System Information"�
screen that includes various serial numbers and software
versions. Call href="http://www.dish-network-satellite-tv.ws/">DISH Network
and customer service representative will walk you through the
rest. With your programming complete, you can begin enjoying
your new satellite system. In addition to browsing programs with
the up and down channel buttons, you can also preview your
channels using the Program Guide.

To access the Guide, press the "�GUIDE"� button on your remote.
You can sort your guide program viewing in a few different ways,
so take a few minutes to customize the Program Guide to suit
your needs.

Enjoy the show!

About the author:
About the Authors: Gary Davis is owner of href="http://www.dish-network-satellite-tv.ws/">Dish Network
Satellite TV and has written numerous articles on the
satellite television industry. Kate Ivy has written for a
variety of publications and websites and is the owner of href="http://www.ivygirlmedia.com">Ivygirl Media &
Design.

Author : Kate Ivy and Gary Davis
Site : www.goarticles.com